Focal 10N500 woofer - 1x RUBBER surround for repair speaker

Please note the inner diameter of the original edge, which may be slightly smaller.

Focal 10N500 woofer - 1x RUBBER surround for repair speaker
9.48 *Prices include VAT
Article code10inchARR-6
PLEASE NOTE: The inner diameter of the new rubber surround offered here is ±182 mm, the original surround has a smaller inner diameter, as you can also see in the photo.
Tip: The old rubber surround on this woofer has become a bit lighter in color. You can largely make this completely black again by using sticker remover. Take a clean, lint-free cotton cloth and soak it in the sticker remover. Do not use too much, as the sticker remover can get on the cone of the woofer and cause damage there. When the old rubber surround is original black again, the gradient between the new surround and the old surround is hardly visible.

Repeated rubbing around on the old rubber usually turns it back to its original black. Before mounting the new rubber surround, you must wait an hour to make the old rubber surround suitable for mounting the new surround. Please note, you should install the new surround after the glue has set a little, until about half to two-thirds of the glue is no longer white, but has become transparent. You should apply glue to both the old rubber surround and the new rubber surround. Then press firmly with a sandwich knife on the back of the cone as a counterforce, so that the cone is not damaged. After 24 hours the adhesive is at its strongest.

NOTE: The foregoing is entirely at your own risk